A simple kitchen replacement replacing your kitchen on a like-for-like design or layout usually takes around a week to fit.

However, as most of our kitchens involve a new design, with changes to the electrics and plumbing, re-plastering and other preliminary work then you can add another week or so to this timescale.

Quartz, Granite and Corian-style worktops will then add several extra days to the overall timescale as these have to be manufactured to order and can only be measured up once the kitchen units are installed.

Other additional work will all add to the timescale such as structural work, new lighting, flooring, tiling etc. Some more complicated installations can take several weeks to install. Your designer will be able to give you an idea of timescales based on the amount of work required to create your new Mastercraft Kitchen.

Planning permission requirements vary based on your location and the extent of your kitchen renovation. Most local councils will require planning permission for extensions and building regulations approval for structural changes. Check with your local building department to determine the necessary permission for your project.

During the installation process, your kitchen may be partially or completely unusable, depending on the extent of the renovation. It’s best to make alternative arrangements for meal preparation, such as using a temporary kitchen set up in another room or relying on takeout meals.

When rust spots appear on a stainless steel sink shortly after installation, it’s often caused by small iron particles, such as those from wire wool used during fitting, contaminating the surface. These tiny fragments, while not the sink itself rusting, bond to the surface and may oxidise, creating rust spots. This is a common occurrence and can usually be resolved by cleaning the affected areas.

To address these spots, you can use a few methods:

Baking Soda Paste:

A gentle, non-abrasive solution like a baking soda paste can help. Mix baking soda with a little water to form a paste, then apply it to the rust spots. Rub gently with a soft cloth, following the grain of the steel to avoid scratches, and rinse with warm water​(

White Vinegar and Water:

For tougher spots, a solution of equal parts white vinegar and water can help loosen the rust. Let the solution sit on the rusted area for 15-20 minutes, then scrub with a soft-bristled brush​.

It’s important to avoid using steel wool, abrasive sponges, or harsh chemicals like bleach when cleaning stainless steel, as these can damage the protective chromium layer that prevents rust​(

Regular maintenance and drying of the sink can also help prevent further rust issues.

With proper care, these spots should dissipate, and your stainless steel sink will continue to look as good as new.